Eureka Tents Tent Tundraline User Manual

ꢀg.8  
ASSEMBLY OF THE  
TUNDRALINE TENT:  
ꢀg.4  
Component List:  
1 Tent Body/Fly, 1 Carry Bag, 2 Poles, 1 Pole Bag,  
1 Stake Bag w/Stakes, 8 Attached Guys w/sliders  
Do not drop tent bag or pole bag on its end. Do not bounce tent bag  
on its end to get the tent out. These actions may cut the shock cord  
and/or damage the pole ends.  
• At the side of the tent, stake out the  
web loops at each pole end. Work  
your way around the tent, adjust  
the stakes, pulling the fabric taut to  
square the tent and remove ꢁoor  
wrinkles.  
• Push the rest of the pole into the  
sleeve, assembling it as you work.  
See ꢀg.4  
• Repeat this with the second pole and  
sleeve at the other end of the tent .  
ASSEMBLY:  
• Unpack the carry bag and separate all the parts. Unroll and unfold the  
tent and lay it on the ground with the black side down. If windy, place  
A
into the wind. Stake down the web loop at A.  
See ꢀg. 1  
See ꢀg. 9  
• This is a tension tent, therefore, do  
not depend upon staking alone to  
keep your tent upright and secure .  
It’s IMPORTANT that you properly guy out this tent. See ꢀg.11  
1. The Tundraline has 4 triangular guy lines, one at each corner attached to  
a pole sleeve. Pull out and stake these ꢀrst.  
ꢀg.9  
• There is a locking post at each end  
of the poles. Fit these posts into  
the web grommets at the sleeve  
ends to create an arch and  
maintain tension.  
A
ꢀg.1  
See ꢀg. 5 and 6  
2. Next, pull out and stake the 2 guys that lead from the peak at each end.  
3. Pull out and stake down the last 2 guy lines from the sidewall .  
• Assemble one half of a  
shockcorded pole. Try  
to prevent pole sections  
from snapping  
together, as this can  
damage the pole ends.  
Make certain each  
ꢀg.5  
• If necessary, adjust the tension on  
the vestibule webs to trim the roof.  
See ꢀg.10.  
• Also, if necessary, move the sliders  
to adjust the tension on the guy  
lines to properly trim the tent walls.  
insert end has seated  
firmly into its ferrule.  
See ꢀg.11  
ꢀg.10  
ꢀg.2  
ꢀg.6  
YOUR TENT  
IS READY!  
• If not already staked, go to one  
end of the tent and drive a  
stake through the web loop at  
the bottom of a vestibule.  
See ꢀg. 7  
• Slide the assembled pole half into the sleeve. Push the pole and pull the  
sleeve toward you, until the locking end tip pokes out from the opposite side.  
See ꢀg. 2 and 3  
ꢀg.7  
• Move to the opposite end of the  
tent. Grasp the vestibule web  
/loop and pull the tent fabric  
taut to raise the structure. This  
ꢀg.11  
is not a freestanding tent. Therefore, you must stake out this web loop before  
Take down: Open doors and pull up stakes. Pull posts out of the grommets  
.
ꢀg.7  
proceeding.  
See ꢀg. 8  
Remove the poles, collapse them and stow. Fold the tent into thirds. Lay the  
poles across the tent, roll up both towards a door and stow all.  
ꢀg.3  
REV. B 4.09  
 

2Wire Gas Grill 1 TB LTU license T2526AA SNM User Manual
3Com Weather Radio WL 548A User Manual
Accusplit Fitness Electronics AL625M8D User Manual
Adcom Stereo Amplifier GFA 7300 User Manual
Adesso Mouse WKB 4000 User Manual
Asus Network Card PEB G21 User Manual
AVerMedia Technologies Network Card M039R User Manual
Axis Communications Tablet Accessory P8221 User Manual
BC Speakers Portable Speaker DCM50 User Manual
Behringer Speaker B2031A User Manual